CIPDB › China Industry › Industrial Equipment & Components › Pneumatic Component
Itvx2000 Series High Pressure Electro Pneumatic Regulator1
Pneumatic ComponentElectro Pneumatic RegulatorElectronic Vacuum Regulator Valve
Ningbo Vpc Pneumatic Co., Ltd.
Preview:
Product Description ITVX2000 Series High Pressure Electro Pneumatic RegulatorProduct DescriptionITVX2000 Series high pressure electro-pneumatic regulator provides step-less air pressure control to an electrical signal. They have an easy-to-read digital pressure display and 3 W or less power consumption. ITVX Series has a 5.0 MPa maximum supply pressure.Product FeatureStepless control of air pressure proportional to an electrical signalStepless control of air pressure in proportion to electric signalsSensitivity: 0.2 kPa (100 kPa specification)Linearity: ±1% or less (F.S.)Hysteresis: 0.5% or less (F.S.)Wetted parts: Fluorine grease How to OrderProduct SpecificationModelITVX2000Min. supply pressureWhichever is higher: 0.5 MPa or the set pressure +0.2 MPaMax. supply pressure5MPa*2)Set pressure range*3)0.01 to 3.0MPaPower supplyVoltageDC24V±10%Current consumption0.12A or lessInput signalCurrent type*4)DC4 to 20mA, DC0 to 20mA (Sink type)Voltage typeDC0 to 5V, DC0 to 10VInput impedanceCurrent type500Ω or lessVoltage type6 to 6.5 kΩ(at ordinary temperature)Output signal*5) (Monitor output)Analog outputDC1 to 5 V (Output impedance: Approx. 1 kΩ) Output accuracy: ±6% or less (Full span)DC4 to 20 mA (Sink type) Load impedance: 250Ω or lessOutput accuracy: ±6% or less (Full span)Switch outputNPN open collector output: Max. 30 V, 80 mAHysteresis: ±3% (Full span), Self-diagnosis: ±5% or less (Full span)PNP open collector output: Max. 80 mAHysteresis: ±3% (Full span), Self-diagnosis: ±5% or less (Full span)Linearity±1% or less (Full span)Hysteresis1% or less (Full span)Repeatability±1% or less (Full span)Sensitivity±1% or less (Full span)Temperature characteristics±0.12% or less (Full span)/oCOutput pressure displayAccuracy±2% or less (Full span) ±1 digitMin. unit *6)MPa: 0.01, kgf/cm2: 0.1, bar: 0.1, psi: 1Working mediumAir, N2, O2, ArWorking temperature0 to 50oC (No condensation)WeightApprox.570g (Without options)*1) Characteristics shown above are based on the piping conditions of Fig. 1. *2) When oxygen is used as a fluid, the maximum supply pressure must be less than 1 MPa.*3) Refer to Fig. 2 for the relationship between set pressure and input signal.*4) 2-wire type DC4 to 20 mA is not available. Power supply voltage DC24 V is required.*5) Select either analog output or switch output. Further, when switch output is selected, select either NPN output or PNP output.When measuring analog output of DC1 to 5 V with a load impedance less than 100 k, the analog output may not obtain the output accuracy of ±6% or less (F.S.).*6) Adjustment of numerical values such as the zero/span adjustment is set based on the minimum units for output pressure display.Note that the unit cannot be changed.*7) This product is only for blowing gas. This product does not have sufficient pressure control for applications other than blowing (driving, sealing, etc.). ITVX2000Option/Accessory TypeDescriptionPart No.Flat bracket assembly (including mounting screws)P398020-600L-bracket assembly (including mounting screws)P398020-601Power cable connectorStraight type 3 mP398020-500-3Right angle type 3 mP398020-501-3 Main DimensionsWiringCautionConnect the cable to the connector on the body with the wiring arranged as shown below.Proceed carefully,as incorrect wiring can cause damage.Further, use DC power with sufficient capacity and a low ripple. Note) The cable is also available in a right angle type. A right angle type connector is attached facing left (toward the SUP port). Do not attempt to rotate, as the connector does not turn.F.G. (Grounding)Ground the frame ground (F.G.) terminal at the front of the main body. If the F.G. terminal port is not used, this product may not operate properly due to the noise.Current Signal Type/Voltage Signal Type 1BrownPower supply2WhiteInput signal3BlueGND (COMMON)4BlackMonitor outputMonitor output wiring diagram Product CategoryPackaging & ShippingPackaging type: VPC BoxWhite BoxColor BoxVPC CartonPalletDelivery time:Conventional ProductsCustomized ProductsSpecially Customized Productson the day of payment10 workdays 25 workdaysPayment term:PaypalTTWestern UnionDPLCMoney GramOnline BankPay laterDAYESYESYESNONOYESYESYES YES Transportation:Express (DHL, UPS, TNT, JCEX, FEDEX) is available.Sea and Air transports are available.The most suitable transport way will be chosen for you.FAQQ1: What is your quality assurance?A: We will inspect one by one before delivery.If the product is damaged in transit or has quality problems, you can choose to refund or resend the product, and the freight will be borne by us.Q2: What is your terms of payment?A: TT, we'll show you the photos of the products and packages before you pay the balance.B: Paypal payment, Bank transfer order also available.Q3: How about the lead time?A: Normally it will take 3-7 days for our routine products.Q4: What is your sample policy?A: Some free samples can be offered if you contact us.Q5: How about the warranty?A: 1 year warranty.
Purchasing Agent
Note: Send your message to supplier or manufacturer.
Welcome to our Professional and comprehensive procurement services...