IPDB › China Industry › Industrial Equipment & Components › Gas Generation Equipment & Parts
Ultrasonic Nebulizer Parts Water Atomiser 180W1
Gas Generation Equipment Parts, Ultrasonic Nebulizer, Ultrasonic Atomizer
Beijing Oksultrasonic Group Co., Ltd
Preview:
Product Description Ultrasonic atomizer The ultrasonic atomizer uses electronic high-frequency oscillation (the oscillation frequency is 1.7mhz, which exceeds the range of human hearing, and the electronic oscillation is not harmful to humans and animals) through the high-frequency resonance of the ceramic atomizing sheet to disperse the liquid water molecular structure. It produces a natural and elegant water mist without heating and adding any chemical reagents. Compared with the heating atomization method, energy is saved by 90%. In addition, a large amount of negative ions will be released during the atomization process, which reacts electrostatically with the smoke and dust floating in the air to make them precipitate and effectively remove formaldehyde. , Carbon monoxide, bacteria and other harmful substances, to purify the air and reduce the occurrence of diseases. Liquid that can be atomized: Tap water, purified water, soft water, electrolyzed water, distilled water and neutral water with a pH value of 5-8. The water temperature is required to be between 10-50 degrees. Liquid that cannot be atomized: Alcohol, washing water, sulfuric acid, sea water, oily, viscous (such asyogurt, soy milk, etc.) acid-base salt liquids, alkaline water has low surface tension and cannot be atomized; acidity and salinity will cause corrosion and should not be used. Control method of atomization water level: 1. It is directly installed in a sink with a water depth of 7-9CM, suitable for occasions where the water level is stable or artificial water is added. 2. Applying buoys to maintain the water level is suitable for occasions where the water level depth is deep or the water level depth is fluctuating and difficult to control. 3. The installation of float valve to limit the water depth is suitable for the use of assembled equipment, and it is used in occasions with strict water level requirements and limited space. 4. Circulating control of inlet and outlet water is suitable for occasions with special requirements for water temperature and circulating water source. Precautions for the use of atomizer 1. The atomizer must be installed horizontally, and it is forbidden to install it at an inclined angle, which will cause the partial atomization sheet to be exposed to the surface of the water and dry and burn. 2. When the atomizer is working normally, please do not put your handson the spray cavity of the atomizer to prevent injury. 3. The atomizer must be in water to work normally. Please put it in the water before turning on the power and make sure that the surface of the atomizer is in a state of water to avoid damage to the atomizer. 4. When you stop using the atomizer, please disconnect the power first, and then take out the atomizer from the water. 5. When using this atomizer, please select a power supply whose output power is greater than the rated power of this product by more than 50w. 6. When multiple atomizers are used in the same container, care must be taken to make the shells of the atomizers communicate with each other to avoid the potential difference between the atomizers in the aqueous solution and electrolysis of the ceramic sheets (atomizers) The shell itself has positive electricity and there is a voltage difference between each other) to prevent discharge corrosion during work. 7. The mist generated by the atomizer must be forcedly discharged by a fan, and each group of atomizers reserves 350CM2 of plane space to avoid excessive water temperature and shorten the service life of the atomizer. 8. Please do not damage the water level sensor switch during the installation process, so as to avoid the failure of the water level switch and cause the atomizer to lose control. Stop using the water level switch if it is damaged, otherwise the atomizer sheet will burn dry and furtherdamage the atomizer. At this time, it must be repaired by professional maintenance personnel before it can be used. MODELOKS-UAH150W OKS-UAH180W OKS-UAH250W OKS-UAH300W OKS-UAH350WRated Power 150W180W250W300W 350WOperating Voltage DC36V DC48VDC48VDC48VDC48VWorking current 4A3.5A5A 5.5A 6AStand-by current 0.02A0.02A0.02A0.02A0.02AAtomization 2000ML/H 2500ML/H4500ML/H5000ML/H 5500ML/HWorking water temperature 5-50°C5-50°C5-50°C5-50°C5-50°CBest water level 7-9CM7-9CM7-9CM7-9CM7-9CMTurn on the water level 5.5CM 5.5CM 5.5CM 5.5CM 5.5CMTurn off the water level <5.5CM<5.5CM<5.5CM<5.5CM<5.5CMTemperature control 55°C55°C55°C55°C55°CTemperature control recovery 40°C 40°C 40°C 40°C 40°C
Purchasing Agent
Note: Send your message to supplier or manufacturer.
Welcome to our Professional and comprehensive procurement services...
Message:
OK ! We suggest you detail your product requirements and company information here.
Enter between 20 to 4,000 characters.
Your inquiry content must be between 20 to 4000 characters.