Tite Bond Quality Liquid Nail with High Strengh Adhesive No More Nail¹

Product Description Product TDS:Serial NO.Test ItemTesting StandardTesting ResultIndividual Evaluation1AppearanceUniform viscous liquid,no suspended matter,no visible mechanical admixture,no phase separation phenomenon,White.Uniform viscous liquid,no suspended matter,no visible mechanical admixture,no phase separation phenomenon,White.Qualified2 Tack free time,min≤207Qualified3Extrudability,ml/min>=250379.5Qualified4Nonvolatile Content,%>=6065.5Qualified5Droop,(N type),mm≤30.5Qualified6Shear Strength(72h),MPa>=2.02.52Qualified7Initial viscosity shear strength(0.5h),MPa>=0.51.12Qualified8Dry heat resistance(90oC,30min)Restore room temperature, no bubble, no crackingNo bubble, No crackingQualified9Storage Conditions----------5oC-40oC,Keep away from open fires and childrenProduct descriptions:Use-method 1.1,Clean the base material surface to ensure no oil and dirt.1.2,Cut the cartridge mouth, poke the aluminum film with a nozzle. Put on the nozzle and extrude the glue with a caulking gun.1.3,Light material sticking method: Put a proper amount of glue on the back of material that needs to be sticked, then put on the base material, then press tight and fit.1.4,Heavy material or fast bonding method: After glue, pressurize and tighten up the material, then gently pull open. Air for 1-2 minutes, then pressurize and tighten up the material again.1.5,Large material no need separation bonding method: Glue on the surface of both material that need to be sticked, scrape the glue evenly with a scraper. Air for 3-5 minutes, then pressurize and tighten up the material.1.6,After pressurize and tighten up the material, 24 hours to reach the use of strength. 72 hours to reach the best strength.Attentions2.1,Liquid nail belongs to solvent volatile product. There will be shrinkage after drying. Shrinkage ratio is related to Solid content.2.2,To achieve fast bonding method effect, must operate according to the above methods after glue: pull open the material 1-2 minutes then pressurize and tighten up the material again. If not operate according to the above methods, but bond directly, then there will be a slight displacement and there will be fall off phenomenon when the material is deformed.2.3,The main function of the liquid nail is the adhesion. It can not be used for sealing. This product is not elastic and aseismic.2.4,Clean up the extra glue with solvent (Tian Na water, banana water, etc) if the extra glue not dry. If the extra glue dry, then strike off the Exserted glue.2.5,.This product can not used to stick the materials which are over 80oC.2.6,This product should be stored in a cool and dry place. Take off the caulking gun after use. Put this product upright.Hint and warningThis product is a chemical product. A slight corrosive reaction to foam, mirrors, paint and mercury. Avoid long skin contact. It must be used in the ventilation. Far away from high temperature and fire. Keep out of reach of children. Avoid polluting water source. After empty packing and unfinished products are dried, please treat them with environmental protectionShelf life: 24 monthsThe Workshop of Our FactoryThe Warehouse and Testing Room of Our FactoryOur ContainersOur ExhibitionsOur Certificates 

OK ! We suggest you detail your product requirements and company information here.
Enter between 20 to 4,000 characters.
Your inquiry content must be between 20 to 4000 characters.